SR/Moose Elevator Horn Bell Crank
Posted: Sun Feb 19, 2012 6:23 pm
Anyone have two spare elevator horn bell cranks FUS-304 and two bearings MI-25. I am missing these parts from my kit. The figure in Chapter 9.2 step 45 shows the part but there are no dimensions. the part should be easy to make if I knew the thickness of the aluminum and the distance between the end holes. The bearing part should be able to be purchased.
If anyone can help with a part or a scale diagram posted to the archives or dimensions, from a part not yet installed, it would be most appreciated.
Reid
Yukon 013Y
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
If anyone can help with a part or a scale diagram posted to the archives or dimensions, from a part not yet installed, it would be most appreciated.
Reid
Yukon 013Y
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------