rivet mandrels
Posted: Sun Feb 19, 2012 6:23 pm
I have been doing a little work on my kit. I have found that about half of the rivets leave a little sharp edge of the mandrel sticking out. Is this common, or if not what can I do to stop it? Should I try turning the air down so it pulls slower? or up to really pull them fast?
Kevin
623R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Kevin
623R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------