[rebel-builders] bell crank CC-47
Posted: Sun Feb 19, 2012 6:15 pm
Hi Ben,
We just went through this so it's fresh; the short arm points forward. This
has been confirmed by MAM. Also, in case you haven't done it yet or seen
the posts, the aft mixer is not symetrical. There's a shot in the manual
that shows how it mounts.
Craig
----- Original Message -----
From: <bransom@dcsol.com>
To: <rebel-builders@dcsol.com>
Sent: Wednesday, March 17, 2010 9:36 PM
Subject: [rebel-builders] bell crank CC-47
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
We just went through this so it's fresh; the short arm points forward. This
has been confirmed by MAM. Also, in case you haven't done it yet or seen
the posts, the aft mixer is not symetrical. There's a shot in the manual
that shows how it mounts.
Craig
----- Original Message -----
From: <bransom@dcsol.com>
To: <rebel-builders@dcsol.com>
Sent: Wednesday, March 17, 2010 9:36 PM
Subject: [rebel-builders] bell crank CC-47
I see a few questions in the archive but no answers. The aileron bell
crank
just left of the control column: Does the short arm get mounted forward?
Dimensions look like that is what is intended, but ???
And maybe this just is a matter of frustration ...next getting to the W-62
round spacers above and below the bell crank bearing. If MAM can supply
3/4" pieces with a 1/4" hole, couldn't they as easily have supplied two
3/8"
pieces with 5/16" holes? True, I've got 20 minutes to cut it roughly in
half,
sand the face smooth enough, and drill it out, but after scratching my
head
over lack of info on the bell crank, then this ...it makes me check my
patience a bit.
-Ben
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------