Moose near calgary?
Posted: Sun Feb 19, 2012 6:15 pm
Might work better over here...
----- Original Message -----
From: "Michael Bleau " <bleaumichael@hotmail.com>
To: "Wayne G. O'Shea " <oifa@irishfield.on.ca>
Sent: Saturday, March 13, 2010 7:19 PM
Subject: Re: moose near calgary?
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
----- Original Message -----
From: "Michael Bleau " <bleaumichael@hotmail.com>
To: "Wayne G. O'Shea " <oifa@irishfield.on.ca>
Sent: Saturday, March 13, 2010 7:19 PM
Subject: Re: moose near calgary?
Does any have or know of a moose close to calgary that has a murphy cowl
finished on it? We have fitted the cowl but need figure how to bracket it
to the firewall and it would be a great help to see one done. If anyone
has any suggestions as always they would be appreciated. Thanks mike bleau
Sent on the TELUS Mobility network with BlackBerry
-----Original Message-----
From: "Wayne G. O'Shea" <oifa@irishfield.on.ca>
Date: Sat, 13 Mar 2010 17:32:49
To: <rebel-builders@dcsol.com>
Subject: Re: [rebel-builders] Worktable height
No issues for me on my 31" high table.... other than it's too low to stand
beside and debur stuff on. Gets hard on the back if you don't pull up a
chair to sit on. My 37" high table on the other hand is perfect for
standing
up while deburing.
As for step stool being needed... buy an 8' long 2 x 12 and put it on two
cement blocks beside the table. Makes life a lot easier when you're at a
stage that requires that extra boost!
----- Original Message -----
From: "Roland Kriening" <kriening@rogers.com>
To: <rebel-builders@dcsol.com>
Sent: Saturday, March 13, 2010 9:42 AM
Subject: [rebel-builders] Worktable height
I am halfway through completing the tailcone and am finding I need a
stepstool to reach into the cone to drill and rivet. My table is
currently
waist height. I am considering lowering the table to a more workable
height
but don't want to do it too soon. I'm sure many of you have gone there
done
that, so I await your advice. Is there an optimum height for working on
the
fuselage? At what point in the build process should I drop the table?
Roland
R56
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
<https://mail.dcsol.com/login>
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
<https://mail.dcsol.com/login>
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------