The Murphy Builders Site

Just wanted to say thanks to Wayne! Dug this up form the archives... saved
me a ton of time and frustration.

Used the method described by Wayne to even out the spade tips, and bring
them in line with the horizontal stab. Worked like a champ!

Thanks, Wayne!

~Kory
678E

-> -----Original Message-----
-> From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com]On Behalf Of
-> Wayne G. O'Shea
-> Sent: Wednesday, March 28, 2007 9:09 AM
-> To: rebel-builders@dcsol.com
-> Subject: Re: [rebel-builders] Elite Elevator Mods
->
->
-> Before you get too far into redoing the other tip...
->
-> When I inherited a Moose project the elevator spades had a good twist in
-> them. I found that by retaining one side at it's original #30 and twisting
-> the spade straight... that the holes on the other side were only misaligned
-> by the the amount necessary to drill them up to a 5/32 rivet. Drilled a
-> couple fresh holes to hold it straight and then brought the old holes up to
-> 5/32 and riveted... cured the twist.
->
-> Wayne
->




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------