Page 1 of 1

gear leg inserts

Posted: Sun Feb 19, 2012 5:58 pm
by Jim Cole
Just wondering if anyone in BC knows Gord Mohr and if he is still
making the gear leg inserts??
Contact info would be great. I have an email address from Bob - just
not sure if it's current.

Thanks
Jim R333

Jim Cole
President
Ran Group Inc
jcole@rangroup.com
1-705-458-9669



On 2010-01-11, at 8:29 AM, Drew Dalgleish wrote:
Nice videos Wayne. Should you have said any landing you can swim
away from?
;) Had a nice flight yesterday sunshine & light winds, it seemed
every sled
was out on the trails as well.

At 11:50 PM 10/01/2010 -0500, you wrote:
Here's some stuff to get you drilling and riveting... from
September 2009...
finally got my buddy's SD card. All of these videos are me
(220lbs), my
buddy (235lbs), 20 to 30 gallons of fuel and the 12' Sportspal on
the side.

Counting in the head.. a thousand and one.. a thousand and two..
the take
offs all seem to be 12 to 16 seconds that we always state around
here.....
but the timer tells no lies in the videos.. generally 25 seconds in
this
configuration.. no wind.. glassy water.
Drew



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------





-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------