Moose flap system
Posted: Sun Feb 19, 2012 5:54 pm
Help. I have the flap system installed and working, however, I can pull
the flap handle on full ( 39 degrees) and its fine when I release to " 0
degrees I goes only to 10 degrees
If I set the turn buckle to get 0 degrees, full flaps only go to 29 degrees
. It looks as though I'm 10 degrees off.
I'm sure there is a simple answer, I'm just too cold to figure it out.
Any help would be appreciated.
Kelly
Moose
kelly@tru-form.ca
Enjoy your day !
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
the flap handle on full ( 39 degrees) and its fine when I release to " 0
degrees I goes only to 10 degrees
If I set the turn buckle to get 0 degrees, full flaps only go to 29 degrees
. It looks as though I'm 10 degrees off.
I'm sure there is a simple answer, I'm just too cold to figure it out.
Any help would be appreciated.
Kelly
Moose
kelly@tru-form.ca
Enjoy your day !
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------