Fibre glass rudder tip 818R
Posted: Sun Feb 19, 2012 5:50 pm
Hi all,
I'm just starting to get my first tip under way and find I can't make
it fit. In order to fit the leading edge rib at the front, and to
accommodate the taper of the rudder at the rear I need to trim off the
joining flange/s and would then have a butt joint between the two halves,
which I would reinforce with fibreglass tape.
Have I missed something? or would anyone care to comment? I've done
some searches and have found some negative remarks but not much detail.
Any input would be appreciated. Cheers Mike
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
I'm just starting to get my first tip under way and find I can't make
it fit. In order to fit the leading edge rib at the front, and to
accommodate the taper of the rudder at the rear I need to trim off the
joining flange/s and would then have a butt joint between the two halves,
which I would reinforce with fibreglass tape.
Have I missed something? or would anyone care to comment? I've done
some searches and have found some negative remarks but not much detail.
Any input would be appreciated. Cheers Mike
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------