upper door latch
Posted: Sun Feb 19, 2012 5:50 pm
I can't find the D-403 aluminum stock material specified for the upper door
latch lever in Ch. 23. Obviously I can substitute other stock. I assume the
thickness is ~1/8" and the cut lever handle width should be roughly 3/4" -
1". Can someone confirm the thickness, and lever/handle width? Thanks.
Ron
254R
http://n254mr.com
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
latch lever in Ch. 23. Obviously I can substitute other stock. I assume the
thickness is ~1/8" and the cut lever handle width should be roughly 3/4" -
1". Can someone confirm the thickness, and lever/handle width? Thanks.
Ron
254R
http://n254mr.com
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------