The Murphy Builders Site

Hi Kevin,

Your AC Kit must be of the older generation. What is your Serial Number?
The AIL-27 part of the newer generation actually have five (5) holes in
them.

If I may suggest, it's best if you can give as much information/details
about your question as you can; such as a specific page or figure in the
build manual that your working on. You're pretty much guaranteed to get a
reply to your question, otherwise it can sometimes be left open ended.

Cheers,
Jeff


On Sat, Nov 21, 2009 at 7:41 PM, kevin curtis <kcs1911@yahoo.com> wrote:

I am very new to this, my first plane and all. The brass bushing AIL-27 has
four holes, but the plans say to rivet it on with three. Which hole am I to
leave?

Yours, Kevin






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Hi Kevin,

Welcome to the group! Jeff's right; depending on which kit you have, older
or newer, the number of holes vary in the AIL-27 flange. No matter which
you have, though, they all get cs rivets.

If you do have an older kit (like me, #207)it would help you to have the
newest copy of the manual. I have found myself going back and forth
between the two as I've built. If you want, contact me email direct and I
can help you with some other stuff I've learned regarding old vs new.
Craig snowyrvr@mtaonline.net

Original Message:
-----------------
From: kevin curtis kcs1911@yahoo.com
Date: Sat, 21 Nov 2009 19:41:14 -0800 (PST)
To: rebel-builders@dcsol.com
Subject: [rebel-builders] rivets in AIL-27


I am very new to this, my first plane and all. The brass bushing AIL-27 has
four holes, but the plans say to rivet it on with three. Which hole am I to
leave?