The Murphy Builders Site

I'm pretty sure I remember mine being this way also Dave. Geesh, I must be
getting old, but I think (can't remember) I took them all out to 3/8" when I
installed larger axle assemblies off of a Cessna AgTruck.

Ted Waltman

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Dave
Greaton
Sent: Friday, November 20, 2009 5:23 PM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] landing gear

The landing gear on my moose have been drilled out to 5/16 on the top holes
and 3/8 on the bottom My axle and brake backing are all 5/16. Does any one
else have this and
have you done,

Thanks

Dave Greaton moose/sr189


No virus found in this outgoing message.
Checked by AVG - www.avg.com
Version: 9.0.707 / Virus Database: 270.14.75/2516 - Release Date: 11/20/09
11:43:00




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------







-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------