The Murphy Builders Site

On the rear bulkheads in the fuel tank, where they meet the top skin and top
of the ribs, there is a small gap between the top flange on the bulkhead and
the rib. The other side slips under the rib flange and can easily be
prosealed. I cannot find the section in the plans that covers this specific
area. Are we to make small angle brackets similar to some of the other
corners...? I must be missing something.

Also, I am ordering tie down rings... where to they attach??


Roland
R56




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------