spreaderbar attach
Posted: Sun Feb 19, 2012 5:41 pm
does any one know or is it safe to assume that the inch and a half
square tube(attach point) on the floats is 6061 T6?The inner inch and
a quarter tube is.
one of these in the kit was a bad extrusion and the inner tube won't
go in.Wanted to make sure before i go get another.
Jason
817R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
square tube(attach point) on the floats is 6061 T6?The inner inch and
a quarter tube is.
one of these in the kit was a bad extrusion and the inner tube won't
go in.Wanted to make sure before i go get another.
Jason
817R
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------