The Murphy Builders Site

Received: from MMoreho699@aol.com
by imo11.mx.aol.com (IMOv14.1) id GRNAa07683
for <murphy-rebel@dcsol.com>; Tue, 26 May 1998 11:12:29 -0400 (EDT)
From: MMoreho699 <MMoreho699@aol.com>
Message-ID: <55f93da7.356adbde@aol.com>
Date: Tue, 26 May 1998 11:12:29 EDT
To: murphy-rebel@dcsol.com
Mime-Version: 1.0
Subject: tailspring bulkhead rivet pattern
Content-type: multipart/mixed;
boundary="part0_896195549_boundary"
X-Mailer: AOL 3.0 for Mac sub 84

Content-ID: <0_896195549@inet_out.mail.aol.com.1>
Content-type: text/plain; charset=US-ASCII

Hello!

Working on R280 03/14/95 page 13-63 fig. 50, it shows Fus 49 tailspring
bulkhead. What is the rivet pattern on the flange on the very bottom? The
next
figure shows only one hole drilled through fus84 (anchor), Fus 49, and the
tailwrap. Do I just drill one hole for now? How about the other small flange
tabs?

Also what do you think about JimsRebel@aol.com's suggestion about skipping
to
the control section now? See re: tail wrap stiffener and fus-57, or download
the attachment (if I'm lucky!).

Thanks,
Dan




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------