The Murphy Builders Site

Does anyone have any tips on how to deburr the rivet holes on the inside of
the stringer flange?

Thanks,

Roger #687R
Eugene, OR USA

*-----------------------------------------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*-----------------------------------------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Roger just use a small file to knock off the burrs flush with the hole. It
shouldn't take more than a minute to do an entire stringer.
Drew

At 02:38 PM 11/14/00 -0800, you wrote:

Does anyone have any tips on how to deburr the rivet holes on the inside of
the stringer flange?

Thanks,

Roger #687R
Eugene, OR USA

*--------------------------------------------------------------------------

---------*

The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*--------------------------------------------------------------------------

---------*
-----------------------------------------------------
Click here for Free Video!!
http://www.gohip.com/freevideo/

*-----------------------------------------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*-----------------------------------------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

From: "Roger & Alice Hoffman" <rognal@continet.com>
Does anyone have any tips on how to deburr the rivet holes on the inside of
the stringer flange?

On visiting the factory while I was building my Zenair 701 I found it was
common practice, in those hard to reach places, to debur with a file. I use
a fine file with the forward edges rounded and one edge covered with duct
tape to make sure no scratches occur to adjacent surfaces. Works well. Just
take some care not to produce any significant scratches.

Don Boardman
SR130


*-----------------------------------------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*-----------------------------------------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------