[rebel-builders] Rebel no.274R PROPELLOR
Posted: Sun Feb 19, 2012 5:33 pm
Hi folks In anticipation of an engine run in the not too distant future I am looking for a replacement blade for my Warp Drive T6195, I have finnished rebuilding the undercarriage and now concentrating on dammage to port wing tip and end section rib its looking good any help is well appreciated thanks Brian
________________________________
From: Jason Beall <super_rebel131@yahoo.com>
To: rebel-builders@dcsol.com
Sent: Thursday, 17 September, 2009 21:53:18
Subject: RE: [rebel-builders] fairleads for moose/SR cable runs/ snap bushings
I was actually thinking about doing this. Thanks, -Jason
[quote]Murphy supplies a white nylon device which resembles a big
nut plate in
shape & installs similar to putting in a nut
plate.
________________________________
From: Jason Beall <super_rebel131@yahoo.com>
To: rebel-builders@dcsol.com
Sent: Thursday, 17 September, 2009 21:53:18
Subject: RE: [rebel-builders] fairleads for moose/SR cable runs/ snap bushings
I was actually thinking about doing this. Thanks, -Jason
[quote]Murphy supplies a white nylon device which resembles a big
nut plate in
shape & installs similar to putting in a nut
plate.