The Murphy Builders Site

Hi Jason

From Bingelis, Firewall forward ....

For lord type mounts... steel spacer should bottom against cupped washers
(approx 185 in/lbs)

Hope this works for you

Nig
745E

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
Rebecca Brownell
Sent: 29 August 2009 22:17
To: rebel-builders@dcsol.com
Subject: [rebel-builders] engine mount torque

Another quick question.I want to final torque my engine mounts.Lyc
0-320 dyno.9140 mounts.Can't seem to find the torque specs
anywhere.Anyone know?
Thanks
Jason
817R



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.409 / Virus Database: 270.13.71/2335 - Release Date: 08/30/09
06:36:00




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------