wingtip installation

[Ralph Baker]

Hi Don,
We created screw removable wingtips for our Elite using nutplates. It required some additional sheet metal boxing and a whole bunch of extra work. Reason was access to the tip mounted strobe power supplies. It is done now but if was a "do over" I would opt for rivets. You can save some time an error by drilling the holes first to #40 with the tip off and then using a strap duplicator (hole finder) to spot the tip drill locations. After all the #40 are drilled and the tip is clecoed on you can final drill knowing the hole locations are correct. That worked fine for us locating the nutplates.
Ralph Baker
Elite 624E (reserved)