reply from MAM r/e torque tubes

[Mike Davis]

Received: from MMoreho699@aol.com
by imo17.mx.aol.com (IMOv13.ems) id GHKRa16330
for <murphy-rebel@dcsol.com>; Mon, 30 Mar 1998 20:15:51 -0500 (EST)
From: MMoreho699 <MMoreho699@aol.com>
Message-ID: <135a3136.352043c9@aol.com>
Date: Mon, 30 Mar 1998 20:15:51 EST
To: murphy-rebel@dcsol.com
Mime-Version: 1.0
Subject: reply from MAM r/e torque tubes
Content-type: text/plain; charset=US-ASCII
Content-transfer-encoding: 7bit
X-Mailer: AOL 3.0 for Mac sub 84

Here's what MAM had to say about my earlier questions:

Hi Dan;
The E.D. on thicker material is not as critical on the thicker materials ,
for example , all of our torque tube horns etc. are common, so the E.D. on
your parts is acceptable . EAA sells a very good book on sheet metal for A/C
in which all of this information is covered , I can't remember the name of,
but they advertise it the back of their Mags.
Hope this helps you,

Dennis>



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------