cc-47 question ???

[Mike Jones]

Hi all

It appears from my manual that the long arm of cc47 connects to the control
tube. Is this correct ?? The manual does not seem to say, it only shows
drawings and they are not dimensioned.

Regards

Mike#007



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[klehman]

Mike
Fig. 32 in my 1992 manual shows the long end of cc-47 pointing towards
the side of the fuselage and the short end pointing forward. However the
long arm of the upgraded 47-1 is only about 1/8" longer than the short
arm. I think there is also a 47-2 but think that is just a 47-1 with a
larger hole for a larger bellcrank bearing.
Ken

Mike Jones wrote:

Hi all

It appears from my manual that the long arm of cc47 connects to the control
tube. Is this correct ?? The manual does not seem to say, it only shows
drawings and they are not dimensioned.

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Wayne G. O'Shea]

Kens right, the shorter arm connects to the sticks push pull tube and the
longer arm to the PP tube going along the door sill, back to the mixer
assembly.

Regards,
Wayne G. O'Shea
www.irishfield.on.ca

----- Original Message -----
From: "klehman" <klehman@albedo.net>
To: <murphy-rebel@dcsol.com>
Sent: Monday, February 04, 2002 9:58 AM
Subject: Re: cc-47 question ???

Mike
Fig. 32 in my 1992 manual shows the long end of cc-47 pointing towards
the side of the fuselage and the short end pointing forward. However the
long arm of the upgraded 47-1 is only about 1/8" longer than the short
arm. I think there is also a 47-2 but think that is just a 47-1 with a
larger hole for a larger bellcrank bearing.
Ken

Mike Jones wrote:

Hi all

It appears from my manual that the long arm of cc47 connects to the

control

tube. Is this correct ?? The manual does not seem to say, it only shows
drawings and they are not dimensioned.

** To unsubscribe, send e-mail to list-server@dcsol.com with

**

** UNSUBSCRIBE MURPHY-REBEL in the message body on a line by itself

**

** Archives located at http://rebel:builder@www.dcsol.com:81/default.htm

**

** To contact the list admin, e-mail mike.davis@dcsol.com

**




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------