The spring gear is available from the factory. You would need
new axles as well. To use the spring gear, extensive mods are built
into the front of the fuselage during construction, adding weight ...
difficult, but not impossible, to retrofit ... Total cost might run to
about $2K, and lots of work ...
If you already have the bungee gear, stick with it ! It is generally
acknowledged to be much lighter, and stronger, as it is triangulated.
The largest majority (~90%) of Rebels here have bungee gear, and it
is considered to add about $5K to the resale value....
......bobp
bobp@prosumers.ca
bobp@pattersys.com
http://www.Pattersys.com
http://www.amway.ca/BobPatterson
De-fenestrate now ! Linux is the answer !
Any views expressed in this message are those of the individual sender
and do not necessarily reflect the views of any other entities or persons.
Any action taken as a result of the contents of this email is totally the
responsibility of the reader.
http://www.danasoft.com/sig/pssignTux.jpg
On Saturday 17 September 2011 00:12:03 Jill Oakes wrote:
Hi Bob
Where are the spring steel landing gear available or plans to mske them?
Thank you
Jill
Sent from my iPhone
On 2011-09-15, at 11:14 PM, Bob Patterson <bobp@prosumers.ca> wrote:Hi All !
I still have a few spray cans of Crown Silicone - the ONLY stuff that
Wayne has found that works on Delrin !! Cable guides, control bushings
...
I will bring them to the meeting again - First-Come basis .... at
$12/can
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
