Preventing Moose/SR stinger side-to-side movement

[Jason Beall]

Guys,

Quick question: I have a custom stinger purchased from another builder a few years back. It's 1 inch in diameter, so there is a slight gap either side of the stinger up in the tailcone where it mounts.

What have others done to take up this gap? I was thinking either delrin spacers or some sort of rubber cushion. Thoughts and/or suggestions?

I can see if you don't prevent the side-to-side movement it will eventually wear the bolt hole on the stinger.

Thanks, -Jason






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------