Good morning everyone,
I've been searching through the archives in vain for a particular post (probably
Wayne's) on the use of a 2x4 clamped to the rear spar of the horizontal stabs as
you position the front attach brackets for drilling through the bulkhead and
doubler. When I try to implement this method, I see no alternative but to to
notch the 2x4 to accommodate the vertical fin. Not difficult to do, obviously,
but I just want to check with the group if there was a 'best-practice' for this
step.
Thanks,
Rob
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
Do you want this big green box to go away? Well here's how...
Click here for full update
Wildcat! photo archives restored.
Click here for full update
Donors can now disable ads.
Click here for instructions
Add yourself to the user map.
Click here for instructions
Click here for full update
Wildcat! photo archives restored.
Click here for full update
Donors can now disable ads.
Click here for instructions
Add yourself to the user map.
Click here for instructions