[rebel-builders] SR/Moose aileron-flap horn bellcrank and CC

[Dick Wampach]

I am getting 1 - 7/8" travel of the cable from full left to right. The bolt
travel for the push pull rods going aft is 1 - 1/4". My sticks were not
installed

I still only have to go down 17 steps to get to my Moose, so this was an
easy check for me. That's one of the advantages of being so darn slow at
building it! I can't think of any other good reasons.
Of course Ted gets to fly in his.

Dick Wampach SR-108 N331RW

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of Jason
Beall
Sent: Monday, November 22, 2010 3:44 PM
To: rebel-builders@dcsol.com
Subject: RE: [rebel-builders] SR/Moose aileron-flap horn bellcrank and
CC-140 paint


Thanks Ted. -Jason

--- On Mon, 11/22/10, Ted Waltman <ted@vafm.org> wrote:

[quote]From: Ted Waltman <ted@vafm.org>
Subject: RE: [rebel-builders] SR/Moose aileron-flap horn bellcrank and
CC-140 paint
To: rebel-builders@dcsol.com
Date: Monday, November 22, 2010, 2:24 PM
I was at the hangar earlier, but now
won't be until well after Thanksgiving,
so, sorry, can't measure aileron side-to-side.

I'd suggest sanding some of the black paint off your CC-140's...

Ted

-----Original Message-----
From: mike.davis@dcsol.com
[mailto:mike.davis@dcsol.com]
On Behalf Of Jason
Beall
Sent: Monday, November 22, 2010 1:02 PM
To: new list server
Subject: [rebel-builders] SR/Moose aileron-flap horn bellcrank and
CC-140 paint

Folks,

Can someone tell me either:

1)How many degrees either way your aileron-flap horn bellcrank in the
ceiling of your SR/Moose moves when you move your stick
back and forth,

or..

2)how many inches from side-to-side your horn moves back
and forth where the
aileron cables attach?

I'm just looking for an approximate measurement. I don't
have my wings
fitted just yet and I want to make sure everything in the roof looks
good.

Second question: My CC-140s control horns have a thick coat of black
paint on them. I'm debating whether or not I want to open up my
delrin bushings a
few thou with my lathe, or sand the paint off the horns.
Any thoughts?


Thanks, -Jason