[rebel-builders] Spring Gear vs. Bungee (or Wayne's Die spri

[srwhitenect]

With the saddles on one end and the angle on the other end of the 5/16 bolts
plus the angle covering the side, it will most likely snap the bolt before
crushing the fuse five. I had trouble with the clearance of the tubes inside
the fuse 5 anyways and felt that they were very slight to begin with. A solid
bushing would do a better job of providing the strength they were looking for.

Steve



On 10/5/2009 10:37 PM, westcoastkitplanes@gmail.com wrote to rebel-
builders:

-> Steve,
->
-> One question, why NO Crush Tubes ? Did you put something else in place
of
-> them ?
->
-> Jeff
->
->
-> On Mon, Oct 5, 2009 at 10:14 PM, <srwhitenect@dcsol.com> wrote:
->
-> > My two cents worth. Built the spring gear as pr manuel plus the angle on
-> > top
-> > of the fuse 5. No cursh tubes. Angle well riveted to fuse 5. Out side
holes
-> > for
-> > the saddles are 3/8" further into the fuse 5's for better edge distance.
-> > Distances given in the manuel got me too close to the end of the tubes.
-> > Angle was 2024-T3 .250 2 X 2 and can't remember the length but was a
bit
-> > longer than specified. Am registered at 1800 lbs gross. Removed the
spring
-> > gear (at 131 hrs) which was a 67 lb change over for floats. All spring
gear
-> > bolts were at torque, showed no signs of working or chafeing on the
shafts.
-> > Have had my share of bump and goes. Will be the ultimate test later this
-> > week after removing the floats, reinstalling the wheels and taking off
from
-> > a
-> > very short sand turf beach. Maybe quite lucky thus far but I do keep it in
-> > mind when I think of where I'd go for a forced landing.
-> >
-> > Steve W 637R
-> >
-> >
-> >
-> > -----------------------------------------------------------------
-> > List archives located at: https://mail.dcsol.com/login
-> > username "rebel" password "builder"
-> > Unsubscribe: rebel-builders-unsubscribe@dcsol.com
-> > List administrator: mike.davis@dcsol.com
-> > -----------------------------------------------------------------
-> >
-> >
-> >
-> >
->




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------