[rebel-builders] Rebel no.274R PROPELLOR

[Brian Bridgewater]

Hi folks In anticipation of an engine run in the not too distant future I am looking for a replacement blade for my Warp Drive T6195, I have finnished rebuilding the undercarriage and now concentrating on dammage to port wing tip and end section rib its looking good any help is well appreciated thanks Brian




________________________________
From: Jason Beall <super_rebel131@yahoo.com>
To: rebel-builders@dcsol.com
Sent: Thursday, 17 September, 2009 21:53:18
Subject: RE: [rebel-builders] fairleads for moose/SR cable runs/ snap bushings

I was actually thinking about doing this. Thanks, -Jason


[quote]Murphy supplies a white nylon device which resembles a big
nut plate in
shape & installs similar to putting in a nut
plate.

[Drew Dalgleish]

Hi Brian Warp drive does a very good job of matching prop blades to each
other. I would hesitate to just grab any blade that fits as it will
possibly be way out of balance. If it was me I'd sent the whole prop to
warp drive for inspection and a new replacement blade.

At 07:27 PM 18/09/2009 +0000, you wrote:

Hi folks In anticipation of an engine run in the not too distant future I

am looking for a replacement blade for my Warp Drive T6195, I have
finnished rebuilding the undercarriage and now concentrating on dammage to
port wing tip and end section rib its looking good any help is well
appreciated thanks Brian

Drew



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Brian Bridgewater]

Thanks for the info Drew