Moose / Super Rebel Wing layout ?

[Nigel Smith]

Hi Guys
Just about to start fitting the MAM Droop tips to my Elite Wings, but the
only info from MAM for the installation is based on a Moose.
Just to clarify the instructions, can any Moose owner tell me if the Moose
wing is the same layout as the Elite wing which is :
Top Surface front to back - front spar/4 stringers/main spar/4
stringers/Rear Spar ?
Bottom Surface front to back - front spar/2 stringers/main spar/2
stringers/rear spar ?
The only place where a top and bottom stringer align is aft of main spar,
2nd upper stringer back aligns (roughly) with 1st lower stringer back ?
Hope that makes sense - a photo direct to nigel at airnig.co.uk would be
much appreciated.
Thanks, and I'll compile an Elite set of instructions and post to the files
area when I get it finished :-)
Nigel
745E




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[kitplane_solutions]

It is the same on the Elite as the SR's same ribs as a matter of fact. You will
find that the wing tips don't line up with the ailerons. You can trim of the
trailing edge and glass it shut again looks much better that way

Sean

On 6/4/2008 6:57 AM, admin@airnig.co.uk wrote to rebel-builders:

-> Hi Guys
-> Just about to start fitting the MAM Droop tips to my Elite Wings, but the
-> only info from MAM for the installation is based on a Moose.
-> Just to clarify the instructions, can any Moose owner tell me if the Moose
-> wing is the same layout as the Elite wing which is :
-> Top Surface front to back - front spar/4 stringers/main spar/4
-> stringers/Rear Spar ?
-> Bottom Surface front to back - front spar/2 stringers/main spar/2
-> stringers/rear spar ?
-> The only place where a top and bottom stringer align is aft of main spar,
-> 2nd upper stringer back aligns (roughly) with 1st lower stringer back ?
-> Hope that makes sense - a photo direct to nigel at airnig.co.uk would be
-> much appreciated.
-> Thanks, and I'll compile an Elite set of instructions and post to the files
-> area when I get it finished :-)
-> Nigel
-> 745E
->




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------