JHDM wheel/brake

[jean.poirier]

Hello

If I understand (without any information from the manual), the brake caliper is
fix to the solid aluminium axel with 4 AN4-10A, 8 washer AN960-416 and 4 nuts AN365-
428. The problem I have, is that no matter if I put the bolt or the nut from the
inside, the "head" is not flat, it hurt the "machined radius" of the axel. The
only solution I could "see" (and some day I am blind) is to grind one side of a
washer to "clear" the radius.

Other solution? Mine look rustic...

Jean
Rebel 747R




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[rognal]

Hi Jean,

I had to file a slight radius on the washer to clear the radius of the
axle/caliper mounting flange.

Roger Hoffman
Eugene, OR USA!



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------