it....
3/4" reamed hole is an AN12 bolt not the AN10 it states or visa vesa. AN10
would be 5/8 holes. I haven't worked on the Moose in so long I can't
remember what real bolt size it was at.
Lower down it states for another 1/2" ream and an AN10 bolt...not correct
either in one way or another..hole or bolt size wrong.
Wayne
----- Original Message -----
From: "Ted Waltman" <tedwaltman@i1ci.com>
To: <rebel-builders@dcsol.com>
Sent: Friday, August 24, 2007 9:35 AM
Subject: [rebel-builders] Moose: manual updates on the tech support page
I just noticed today that there are quite a few (new, dated Aug 2007)
manual
updates listed on the Moose Technical Support page. It's GREAT to see
someone (Geoffrey?) getting active in sharing information at Murphy
Aircraft!
http://www.murphyair.com/murphyair/Airc ... chSpt.html
Ted
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------
