[rebel-builders] RE: MOOSE: Aileron travel

[Rick Muller]

Found the update on the Murphy site! Thanks!

Rick Muller
(303) 664 9219 Home
(303) 641 6623 Cell
rickhm@comcast.net

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com] On Behalf Of
sa@dcsol.com
Sent: Tuesday, April 24, 2007 7:38 AM
To: rebel-builders@dcsol.com
Subject: [rebel-builders] RE: MOOSE: Aileron travel

What is the date on the manual? They changed it in 2002 - it shows the
horn (the one on the end of the tube that comes out of the wing) set at zero
degrees or vertical.



On 4/23/2007 4:12 PM, rickhm@comcast.net wrote to rebel-builders:

-> I read through what I could find on the list regarding the controls for
the
-> moose/2500. My manual indicates that the angle between vertical and the
-> horn for the torque tube is 50 degrees. Apparently there has been some
-> variation here, others indicated 54 degrees. When I move the stick left
and
-> right I see interference between the push rod and the horn of the torque
-> tube as it pushes the horn forward. I do not get full travel!
->
-> The next issue is what is full travel? I cannot find in the manual what
the
-> travel of the aileron should be? What are others seeing?
->
-> Rick Muller
-> (303) 664 9219 Home
-> (303) 641 6623 Cell
-> rickhm@comcast.net
->
->




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------