Bad FUS-409 and FUS-411 parts

[Eric Fogelin]

I just resolved a problem with Steve Cooper at Murphy concerning the
elevator pulley brackets that are located in the tail of the Elite. The
pulleys provided (BB-128s) were correct 2" diameter pulleys, but both the
FUS-409 and FUS-411 brackets seemed to be for 1.5" pulleys.

Parts did not align correctly and/or there were interference problems. I
uploaded photos of the bad parts in the Elite Control section.

My kit is Elite 645 and was packaged in early 1999. I do not know if the
Rebel or Moose use the same brackets, but other kits shipped from the
factory around this date might be worth checking.

Steve resolved the problem quickly with new brackets.

Eric




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------