Torque Tube Bases (was Elite wings)

[Hibbs]

Doug, I just installed the bases on the left wing of my Rebel. It was a
pretty close fit and I had to bend the sides a bit (they had "sprung" a
little), but I was able to fit mine in level and away from the radius by
about 1/16". I noticed that while it looked like the bases were a
little high (toward the top skin), they really were ok. Check for skin
clearance with a scrap piece of .020. Hope this helps. If you still
can't get a fit, write me and I'll measure my rear spar and bases to
compare to yours.
--
Best Regards,

Scott Hibbs
hibbs@pacifier.com


From: "Snader, Douglas E." <snaderde@tvfr.com>
To: "'murphy-rebel@dcsol.com'" <murphy-rebel@dcsol.com>
Subject: ELITE WINGS

I am in the process of putting the bearing bases................


*-----------------------------------------------------------------------------------*
The Murphy Rebel Builders List is for the discussion
between builders and owners of Murphy Rebel aircraft.
Archives located at:
http://www.dcsol.com/murphy-rebel/lists/default.htm
*-----------------------------------------------------------------------------------*




-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------