[rebel-builders] shrinker-stretcher

[Drew Dalgleish]

This guy sells shrinker dies that won't leave the lines that others do.
Probably quicker easier and cheaper to just buy a new corner wrap tough.

http://tinmantech.com/index.php


At 04:46 PM 5/19/2006 -0800, you wrote:

Before getting my methods figured out (the educational part, you know), I
slightly stretched the edge of one of my fuse corner wraps when trimming off
the edge (long edge, where it rivets to side skin). Can this be taken out

with

a shrinker stretcher without marring the surface? I used an old shrinker-
stretcher once before, and although it did the job, it marred the surface
some. I'm wondering if a nicer tool would do the trick or am I better off

just

getting another corner wrap. (i'm running low. ;-) )
-Ben



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Drew



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

[Robert Andrews]

Anyone tried making corner wraps? Keith made some using a roller and a
break with one side clamped down and the other up. It took a few tries, but
got pretty close to the MAM product ... good enough to be my new right front
wrap.

Bob 612e

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com]On Behalf Of
Drew Dalgleish
Sent: Saturday, May 20, 2006 8:02 PM
To: rebel-builders@dcsol.com
Subject: Re: [rebel-builders] shrinker-stretcher


This guy sells shrinker dies that won't leave the lines that others do.
Probably quicker easier and cheaper to just buy a new corner wrap tough.

http://tinmantech.com/index.php


At 04:46 PM 5/19/2006 -0800, you wrote:

Before getting my methods figured out (the educational part, you know), I
slightly stretched the edge of one of my fuse corner wraps when trimming

off

the edge (long edge, where it rivets to side skin). Can this be taken out

with

a shrinker stretcher without marring the surface? I used an old shrinker-
stretcher once before, and although it did the job, it marred the surface
some. I'm wondering if a nicer tool would do the trick or am I better off

just

getting another corner wrap. (i'm running low. ;-) )
-Ben



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

Drew



-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------







-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------