[rebel-builders] Moose: Newly installed -- straight -- sting

[Wayne G. O'Shea]

Did you take the foam out of your tailwheel so the air can do it's job??

Wayne

----- Original Message -----
From: "Ted Waltman" <tedwaltman@i1ci.com>
To: <rebel-builders@dcsol.com>
Sent: Friday, May 05, 2006 9:09 PM
Subject: [rebel-builders] Moose: Newly installed -- straight -- stinger

I installed a new prototype -- totally straight -- stinger on the Moose
today. I also put on a new swivel that a machinist friend of mine created
out of a blank-stock swivel that Murphy Aircraft sent. I uploaded a

picture

of the install in the "115 S/M Landing Gear" area. The picture shows that

I

now have a slight positive castor angle when relatively empty. With the
plane loaded up I suspect I'll have the proper vertical pivot pin
orientation.

You can also see two pictures (very bottom of the page) and more info on

the

tail upgrades at: http://www.i1ci.com/flying/Moose/Tail/TailUpgrade.html

Ted Waltman




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------