Setting up shop

[Mike Davis]

I don't know that I'd worry to much about that... I have a hard time getting
kerosene to burn off the concrete floor with a torch. As long as a keep the
torch on it, it will burn, but as soon as I remove the torch, it goes out.
And if you're wondering why I have kerosene on the floor, it's what drips
when filling my heater. ;-)

Mike

----- Original Message -----
From: "Wayne G. O'Shea" <oifa@irishfield.on.ca>
To: <rebel-builders@dcsol.com>
Sent: Saturday, December 18, 2004 4:52 PM
Subject: Re: Setting up shop

Does it mix well with the brush sparks from a motor?

----- Original Message -----
From: "Ted Hauri" <bosdes@att.net>
To: <rebel-builders@dcsol.com>; <rebel-builders@dcsol.com>
Cc: "Wayne G. O'Shea" <oifa@irishfield.on.ca>
Sent: Saturday, December 18, 2004 8:49 PM
Subject: Re: Setting up shop

Kerosene is a good lubricant when cutting aluminum with a bandsaw. Ted

Hauri

-------------- Original message from "Wayne G. O'Shea"

<oifa@irishfield.on.ca>: --------------




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------