Elite Spring Gear crush tubes & compression block questi

[N.Smith]

Thanks Wayne

I'll go for a few blobs of Sikaflex

Nig

-----Original Message-----
From: mike.davis@dcsol.com [mailto:mike.davis@dcsol.com]On Behalf Of
Wayne G. O'Shea
Sent: 23 November 2004 18:18
To: Murphy Rebel Builders List
Subject: Fw: Elite Spring Gear crush tubes & compression block question


The word "crate" is of course supposed to be create!

----- Original Message -----
From: "Wayne G. O'Shea" <oifa@irishfield.on.ca>
To: <rebel-builders@dcsol.com>
Sent: Tuesday, November 23, 2004 1:12 PM
Subject: Re: Elite Spring Gear crush tubes & compression block question

Nig, one more before I get back in the shop! I Sikaflexed the blocks in
place. Any thing..proseal, RTV etc would do.

The single 3/8" leg retainer bolt I put the nut on the outsid..... where
it's easy to properly torque. The saddle bolts probably have some merrit
going in from below as if you stripped a nut in a hard arrival the bending
bolt might crate enough friction to hold you up somewhat to negate a prop
strike.....although it definitely will add a bit of work to switching over
to the float brackets like you have envisioned!

Cheers,
Wayne

----- Original Message -----
From: "N.Smith" <admin@airnig.co.uk>
To: <rebel-builders@dcsol.com>
Sent: Tuesday, November 23, 2004 12:55 PM
Subject: Elite Spring Gear crush tubes & compression block question

Hi All

Just a quick question about the spring gear compression tubes SG-10 and
compression block SG-5 that surround the AN5 and AN6 bolts holding on

the

gear legs inside the FUS 5 carrythrough's.

The manual shows the bolts going in from underneath, with the nut on the
top.

My question is has anyone had a problem when changing from spring gear

to

floats or the other way round and whilst the bolt is removed the

compression

tubes or block move and cannot be relocated around the bolt. If the bolt

was

mounted from above the nut could be removed and the bolt left more or

less

in place lying through the fuselage so the tubes remain located

correctly.

The other option may be to "glue" the tubes in position before the floor

is

riveted down ?

Ideas, or am I just worrying about a non event (hopefully starting to

rivet

the floor down later tomorrow so thought I'd check :-)

Nigel
745E




-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------

-----------------------------------------------------------------
List archives located at: https://www.dcsol.com/login?mode=HTML
username "rebel" password "builder"
Subscription services located at:
https://www.dcsol.com/public/code/html-subscribe.htm
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------






-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------