(not the spar) so it would be a large stretch to think it strengthens
the wing.
Ken
Wayne G. O'Shea wrote:
Probably pretty close Bruce! I don't remember what gauge it was made out of
but by estimation the cuff has to be at least a 16" piece of aluminum
(likely wider) and there's 24' of it. That's a minimum of 2/3rds of a 12'
sheet of aluminum. Therefore if it's .020 = 9lb, .025 = 11.3lb, .032 =
14.7lb for the cuff skin, then add a few pounds for rivets, the foam ribs
and adhesive. Add to that as well the wing fences made out of .063"? (I
believe) are good for 3 lbs/set.
Wayne
----- Original Message -----
From: <Legeorgen@aol.com>
To: <murphy-rebel@dcsol.com>
Sent: Wednesday, November 12, 2003 7:08 PM
Subject: Re: Borer Prop for Rebel on Floats
leadingThe STOL kit can't weigh that much. It's only like an extra layer of
edge skins. Well, maybe it can act as the thicker Elite leading edge and
increase the gross to 1850 lb. Unofficially of course.
Bruce
*-------------------------------------------------------------------------*
To unsubscribe from this list go to:
https://www.dcsol.com/public/code/html-subscribe.wcx
Archives located at https://rebel:builder@www.dcsol.com/default.htm
To contact the list admin, e-mail mike.davis@dcsol.com
*-------------------------------------------------------------------------*
-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------