Tank drain holes, aileron hinge insp. holes, control horn ce

[Mike Davis]

Received: from MMoreho699@aol.com
by imo26.mx.aol.com (IMOv13.ems) id GIYKa02202;
Wed, 8 Apr 1998 13:03:22 -0500 (EDT)
From: MMoreho699 <MMoreho699@aol.com>
Message-ID: <7dd5b1e.352baddc@aol.com>
Date: Wed, 8 Apr 1998 13:03:22 EDT
To: murphy-rebel@dcsol.com, murtech@murphyair.com
Mime-Version: 1.0
Subject: Tank drain holes, aileron hinge insp. holes, control horn center
hole
Content-type: text/plain; charset=US-ASCII
Content-transfer-encoding: 7bit
X-Mailer: AOL 3.0 for Mac sub 84

Hello!

How do you feel about water drain port for the tanks? I haven't put them in
yet and recall one person saying they had a water trap at the lowest point
of
the fuel system. This was in the line somewhere, not in the tank itself.

I also installed an aileron hinge inspection hole on the bottom as opposed
to
Murphy's recommendation of having topside access. I did this only for the
middle hinge and could move to the top for the other. Ideas?

And the control horns have center holes through which a bolt is TEMPORARILY
placed, not permanently, right? And what is the #11 hole drilled 1.5" from
the
distal hole of the root end control horn for?

Remember: Lowering expectations is a key to peace of mind!
Dan
R280



-----------------------------------------------------------------
List archives located at: https://mail.dcsol.com/login
username "rebel" password "builder"
Unsubscribe: rebel-builders-unsubscribe@dcsol.com
List administrator: mike.davis@dcsol.com
-----------------------------------------------------------------