The Murphy Builders Site

Welcome to the addiction Tom! I did the same thing in 1993 without ever seeing a Rebel in person! At least one builder in Washington state on Amphibs.. probably a few more.

You could probably clamp them in a vice and counter sink them a little larger to accept the dimples. Another option would be to use clip nuts instead, that I was selling to the lads a few years back. I still have trays full of them at 50 cents each. I probably have the nytrol/fibre anchor nuts as we...

Two ways to get it.. order from Murphy or bend it up yourself from sheet stock. It's not a common part that anyone else is making/using, it's a part Murphy bends up specifically for it's fleet of a/c and floats.

After watching Bob bring his Elite in today in the rain, temerature @ 7C (30+ miles visbility) my thoughts went to making sure everyone here is at least putting some holes in their panel top decks so the warmth from the radios or cabin heat can go up the windshield. He may have had 30 miles vis... b...

Closest thing I can come up with to call it is a Gudgeon Clip. You're looking for a spring clip with two tabs to stick in each side of the nut castlation? Why not just drill thru the pivot bolt and use a cotter pin?

I think you're looking for a "PTO" pin Drew. Pin and a semicircle lock bail. Saw a good selection last time I was in TSC.

Wayne

Forgot to reply... have none! Sorry.

An old habit of reading the emails and responding to them later. The step of having to come into the forum to reply just gets lost some days..

Can't remember if I have any spares.. will have a boo tomorrow.

Now there's a shot for the photo album!! I have mine with all three kids sitting in the fuselage, in 1994, with Daryl holding a flight sim yoke in his hands!